helloearth.info ~ Electicity for Health ~ Magnetic Pulser ~ Specifications

Electricity for Health
Magnetic Pulser
Specifications

Saturn Earth Connection
introduction

Michael Connection

Urantia Connection

NASA Connection

Riley Connection

Drink Ozone Water

Nikola Tesla

Electricity for Health
Magnetic Pulser
Specifications

Color Light for Health

about us

High Intensity
Momentary Time-Variant Pulsed DC
Magnetic Field Therapy Generator

Disclaimer: Please understand the SOTA Products are not intended to cure or treat any specific disease.
The products have not been evaluated by any government for safety or effectiveness. (They don't intend to).
Government regulators consider testimonials to be misleading and deceptive (yes that is a possiblility) and
recommend you consult a medical doctor for the treatment of all diseases. (Then it is up to you)

The Magnetic Pulser
is a professionally designed quality unit, thoroughly tested and guaranteed to operate as per the specifications.
The Magnetic Pulser is designed to generate an intense ~6,000 Gauss*, momentary ~2.5mS pulsed DC magnetic field.

For Gauss calculations
and an in-depth discussion on the electrical principles at play with SOTAs Magnetic Pulser.

*Magnetic flux intensity follows the inverse square rule ~
the further you are away from the magnetic core,
the faster the Gauss intensity drops off. At the face of Magnetic Coil, the Gauss is 6,000 Gauss.

Model # MP5

Please note that all purchases from Canada and countries other than the US
will be converted and processed in Canadian funds. If the US dollar continues
to slide in value our pricing will need to increase. Over the last seven years
we have seen the US dollar drop in value by over 50%. We can maintain
our pricing as long as the US dollar stays near par with the Canadian dollar.

Please note that all purchases of SOTA products
are subject to the laws of British Columbia, Canada.

More features to talk about

Operates from an AC-DC Wall Adaptor included,
or from a 12 Volt DC source like an automobile battery, appropriate solar panel, etc.
We have adaptors that have blades for North America, Hong Kong, Europe, and Australia.
Please specify when ordering.

Extremely high magnetic power output
Generates maximum 42.18 Joules (Watt*Seconds)
of energy through the use of a 600uF, 330VDC Custom Photoflash Capacitor.
This then produces ~6,000 Gauss* (~6 kilo Gauss) magnetic field inside the coil.

High-Frequency Custom Switch
Mode Pulse-Width-Modulated power supply allows for fast charges and a very lightweight unit.
Our power supply is a constant-current design.

Double-insulated practices used throughout
to ensure the greatest electrical safety.
Coil is completely enclosed in a custom-molded plastic Hand Paddle.
No exposed wires or leads.

New Professional Capacitor
We now have a Professional Custom Strobe type Capacitor designed specifically for our Magnetic Pulser.
The manufacturer rates the capacitor at well over a 30 million (30,000,000) cycles of operation.
Compare this with our earlier version model MP2 and MP3 which had a 250,000 cycle life, or to our MP1
which had a 85,000 cycle life, or even to photoflash based pulsers that have 5,000 - 10,000 life cycle.

New Features of model MP5

Streamlined case.
Quartz crystal Micro-Computer controlled functions for precise waveform generation and accurate timing sequences.

Red Light indicates when Magnetic Pulse has been delivered to the Hand paddle/Coil.

AUDIBLE output
Unit beeps each time magnetic pulse is released to coil

Unit will pulse for 20 minutes (255 pulses) before resetting.

Slightly higher output pulse intensity

New soft carrying case

Unique Features

New Hand-Paddle design
Our pulsing coil has been re-designed into a custom molded plastic enclosure
complete with clear identification of the Bio-North (-) Magnetic Pole.

A unique circuit design allows
The Magnetic Pulser to operate without the use of a Xenon flashtube
allowing for maximum power delivery to the coil.

Fully Automatic
The MP5 will automatically charge and discharge - no manual pulsing required.
An internal Digital Counter allows the MP5 to pulse approximately 20 minutes between resets.

LED light bar-graph
A light bar-graph consisting of five Green LED lights,
illuminates sequentially giving visual indication of the MP5 charging up.

A Red LED light indicates
either the unit has completed a 20 minute cycle of pulses, or
an overload condition has occurred.

Fast charging cycle

Overload Protection
Should an overload or fault condition occur in the charging section,
a sensor will limit the current, then eventually shutdown the unit until the fault condition is removed.

Bio-North Magnetic Pole Polarity (-) or South-Seeking
is clearly identified on one side of pulsing coil. This gives the user
the choice of applying either Bio-North (-) or Bio-South (+) pole energy to the site.

Our Electrical Circuit Boards are GOLD Plated for extreme reliability and workmanship.

Compact and lightweight
MP5 unit weighs 3/4 Lbs. 0.3 Kg.
Magnetic coil weighs 1 Lb. (0.4 Kg.).
Total shipping weight of complete MP5 with Wall Adaptor ~3 Lbs. ~1.3 Kg.

3 Year Parts and Labour Warranty on internally mounted components

Custom Strobe type Capacitor designed specifically for
our Magnetic Pulser

CE Certification
RoHS Compliant

Electronics

The Magnetic Pulser is designed to the highest standards.
We have improved on the original design with added features.
Our electronic design is unique and efficient making the unit very reliable and powerful.
Early designs required the use of a Xenon flashtube. We've completely re-designed The
Magnetic Pulser from the ground up using the latest in electronic components. The result is
a very powerful, reliable, rugged unit that transfers more energy to the output coil. In addition,
we use double-insulation techniques to ensure the greatest in electrical safety.
This is of extreme importance.

Specifications
as measured on a Tektronics TDS 210 Digital Real-Time Oscilloscope,
and Wavetek AD105 Clamp-On RMS Ammeter

Energy Storage Capacitor: 600uF, 450 Volts DC Click here to see our MP capacitors
Typical Energy Storage: 36.75 Joules (Watt*Seconds)
Maximum Energy Storage: 42.18 Joules (Watt*Seconds)
Typical Peak Charge Voltage: 350 Volts DC
Maximum Peak Charge Voltage: 375 Volts DC
Minimum Peak Current Discharge into Coil: 150 Amps RMS
Pulse Rise Time: <1.8 uS (microseconds)
Pulse Duration: ~2.5mS (milliseconds)
Main Coil Inductance: ~2.5mH (milli-henries)
Flux Density: 40,500 Ampere*Turns
Peak Magnetic Field Output: ~6,000 Gauss* (~6 kilo Gauss)
*Magnetic flux intensity follows the inverse square rule ~
the further you are away from the magnetic core,
the faster the Gauss intensity drops off.
At face of Magnetic Coil, the Gauss is ~6,000 Gauss as measured on an F.W. Bell Model 5080 Fluxmeter. Minimum number of Pulse Discharges 30 Million (30,000,000)